WOAH! That dB change from the intro vocal to the cutscene is drastic!! Just want to point that out immediately Some Compression / Limiting is defintely needed there. ok, now to try and watch the actual info Edit: Good lil rundown of what I needed to catch up on since my last update on Orca. Liked n subbed for future infos.
I’m having an issue with the nozzle scraping the infill. Orca did not seem to care if I had zhop enabled or not. I changed the infill pattern to get it to stop but there has to be some setting that will fix it for all infill. All prints look good. No other issues. Any ideas? FF AD5M. Orca-FF and Orca 2.1b.
10:59 if you have a good printer, improvement from opt out autocooling for outer walls will probably only be visible on glossy prints.
Thank you for the info. I pinned your comment.
WOAH! That dB change from the intro vocal to the cutscene is drastic!!
Just want to point that out immediately
Some Compression / Limiting is defintely needed there.
ok, now to try and watch the actual info
Edit: Good lil rundown of what I needed to catch up on since my last update on Orca. Liked n subbed for future infos.
Sorry about the sound. If I edit (I think) in future uploads.
I’m having an issue with the nozzle scraping the infill. Orca did not seem to care if I had zhop enabled or not. I changed the infill pattern to get it to stop but there has to be some setting that will fix it for all infill. All prints look good. No other issues. Any ideas? FF AD5M. Orca-FF and Orca 2.1b.
There should be a setting for zhop distance. Try to increase that and see if it helps. Let me know.
Does the new version have camera capablit built in for printers using the stock camera and not a USB one?
I am not sure.
Just moved to orca 2.1.1 and unable to find how to search for a particular setting, can you advise?
I like your content and delivery, excellent.
At the top of each section, you should see a little magnifying glass. You can use that to search settings. Let me know if you see it.
@@minimal3dp Found it, surprised I had not seen it looking for exactly that icon. Thanks
With Orca I kinda like 3d honeycomb over adaptive cubic, but I haven't done a lot of testing.
I will take a look at it. I appreciate the feedback.
Hi. Where do you go to setup, or remove filament??
There is a filament section in the slicer settings. You can also go through the setup wizard and check and uncheck various filaments.
As of this If you have an older Mac hold off on the update of 2.1.1 as there are issues that they are working on.. Crashes and does not start
Thanks for the information..
I can confirm this.
Does it support Voron 2.4?
The is a voron 2.4 profile. I am currently building a corona, so I have not tested it directly.
I wish I could change the look. I hate that green/gray color scheme. Yes I know that there is a dark/light option.
I liked the old logo better. I like dark otherwise.